Interested to Buy Any Domain ? << Click Here >> for more details...
Difference between Statics, Dynamics, Kinetics, Kinematics
- 5 Answers
- 51248 Views
- Cinda, I also Faced
- E-Mail Answers
Answer Posted / b janarthanan
Statics - study of forces on rigid body which is stationary
Dynamics - study of forces on rigid body when it is in motion
Kinematics - branch of dynamics without considering forces
causing motion
kinetics - branch of dynamics considering the forces causing
the motion
| Is This Answer Correct ? | 185 Yes | 23 No |
Post New Answer View All Answers
what is civil engineer greatest strength and weakness?
hi every body..i have applied for RRB section engineers CIVIL.i wanna prepare for that,so can any one suggest me some books and where can i get the syllabus for this..i would be vry greatful if any one can help in this regard
cause of cylinder test failure
I measured pcc work as 15.34 m cube , the ratio is 1:5:10 ,want to know the cement, sand and metal used for pcc measured as 15.34 m cube at this ratio.
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
i want texture painting pwd data
how i convert mm into standard wire guage (SWG)no.
what is the criteria for the finalisation of pavement thickness in road project?
How to identify the vitrified tile and ceramic tile by observation only after executing the job.
How much for the BRC lapping in full yield and half yield < and which table to get it ?
how much need cement bags for block work of wall approx 1000 hollow blocks 20x20x40cm
cement and sand required for one block of size 0.23*0.15*0.46
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
How to find out slope footing concrete
How to estabilish reinforcement Steel rolling margin for a building projects ?
