Interested to Buy Any Domain ? << Click Here >> for more details...
WHY WE CAN GENERATE POWER IN 3PHASE MODE ONLY NOT IN 4 OR 5
PHASE?
- 8 Answers
- 10507 Views
- I also Faced
- E-Mail Answers
Answer Posted / palak shah 09879803533
since the waveform of current or voltage is sinosuidal so v
can only generate 3 phase. also if v use 4 phase the 180/4=
45 degree would be distributed and so motor will run for
sometime then stop for sometime and the again run for
sometime....... so ultimately windings will burnt.
thanks
palak shah
09879803533
| Is This Answer Correct ? | 1 Yes | 8 No |
Post New Answer View All Answers
Define non-touching loop.
11 kV line deraction check by an Engineer.
Can RCD's used to protect the VVVF drive if not why.
how to get bearing & winding temperature of an induction motor?
What is nyquist contour?
700KW 6.6KV slip ring induction motor to use VFD to control the speed
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
How to calculate VCB rating for 33KV ,25 MW Power line?
How to calculate the efficiency of Turbo Generator(Alternator) in general....?
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
Explain the construction of the conservator, operation and purpose, and draw the diagram of the conservator.
