Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / venu gopal
It is used in construction when you are working with
reinforcement steel. when you are at the end of any bar and
it has to be further extended to some more distence then
you are supposed to join it with an other bar (what ever
may be the dia) to this job simply we cannot do it. there
is a design and it depends on the location and design. in
most of the cases it is 50 times the diameter of the bar
which you are laping in some cases it may be 40times the
dia and in some drawings base on the requirementt and
design it will be a standardlength (300mm,400mm soon....)
| Is This Answer Correct ? | 128 Yes | 13 No |
Post New Answer View All Answers
1) What is meant by C-soil in geotechnical Engineering? 2) What is Eve board? 3) What will happen when heat is applied to cement? 4) what do you understand by the lateral dimention ?
Which architectural movement is also known as jazz moderna?
Hollow block masonry in cement mortar 1:4, 40×20×20cms in superstructure take 10sqm.I want calculation of brick sand
I have an plot with area 35*47 = 182.77 sq yards. Out of this iam planning to construct house with 1350 sqfeet each floor .iwanted to build a G+2 house.Need cost estimation for each item
what is the permanent solution applied for restoration of leaning tower of pisa?
crank types
how can can column be corrected when the design is not safe ? is the increasing the clearcover a solution?
How to test cement,sand,20mmbluemetal,40mmbluemetal,bricks,concrete by visual and instrument
What will be weight of 0.5mm GI sheet per sq.ft?
how to shuttering is used in slab
What you understand by building codes?
what happening if we casting HV shunt reactor foundation pad at 50cm height different time (One day difference)
How much quantity of rod binding work by a rod binder per day
How much area, in square meters, will one liter of paint cover if it is brushed out to uniform thickness of 600 microns?
how much quantity of 1.5" nails and 2.5" nails are required for conventional formwork shuttering?
