Interested to Buy Any Domain ? << Click Here >> for more details...
1. How many output signals do wew have in process control?
2. Could you write down the names of the pre-commissioning
and commissioning stage test instruments and explain them
(more than 5 items)?
3. What is the first step to commission a transmitter on
service?
4. What is RTD?
5. Find the output value in MA of a temperature transmitter
(RTD Type) at 120degree celius?
6. What is the O/P signal of a pneumatic transmitter?
7. What is the O/P signal of an elctronic transmitter?
8. What is the close loop and open loon?
- 4 Answers
- 10920 Views
- I also Faced
- E-Mail Answers
Answer Posted / p.sharathreddy
4. o/p signal of electronic transmitter is 4-20 mA and 1-10 mV
dc
| Is This Answer Correct ? | 1 Yes | 8 No |
Post New Answer View All Answers
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
How to check vortex flow meter is in good condition while we do not having calibration setup?
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
What is the meaning of wet leg
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
Explain the key components of control loop?
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
What is cut off relay? And why use in PLC and DCS?
Explain Gas Turbine startup and shutdown sequences
selection of the zener barrier for the hazardeous area zone 0
