Answer Posted / gunasekaran
if fuse is blown unbalance is occurred so it will destroy
the equipment so link is recommended
| Is This Answer Correct ? | 2 Yes | 7 No |
Post New Answer View All Answers
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
how much LT load can bear by the 100 KW HT connection.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
WHAT IS ELECTRICAL MAINTAINTENCE ?
What are the various kind of cables used for transmission?
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
What are the advantages and disadvantages of short-pitched winding?
what is transistors comprised of?
what will be the min and max voltage flow from neutral to earth?
What is core CT & it's function?
What mean by MLTP
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
What is a system?
