Interested to Buy Any Domain ? << Click Here >> for more details...
why the power factor in inductive load is lagging while it
is leading in capacitive load?
- 6 Answers
- 19007 Views
- I also Faced
- E-Mail Answers
Answer Posted / gunasekaran
inductance always oppose the change in current
capacitor always oppose change in voltage so capacitor
leading PF inductor lagging PF
| Is This Answer Correct ? | 11 Yes | 7 No |
Post New Answer View All Answers
Why is negative feedback invariably preferred in closed loop system?
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
why we not used 11kva as a direct our electrnics component.
How wire size can define in electrical wiring? What is the ratio?
we need a ntpc previous papers
what is the difference b/w UHVDC and HVDC(LIGHT)?
Which device of PlC does share load between DG sets when DG are running in perallel?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
tan delta equation test on alternators
how to calculate insulation level of transformer?
How to choose size of the cable w.r.to current carrying capacity ...
How we can come to know the substation range,without go through any name plate ?
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
how much cable size required for 70 kilowatt load.
