Interested to Buy Any Domain ? << Click Here >> for more details...
sir please send me previous year questions of jspl through
which i could prepare myself fpr the test.
- 64 Answers
- 67541 Views
- FGH, HFT, Jindal, Jindal Steel and Power, JSP, JSW, Lin Engineering, I also Faced
- E-Mail Answers
Answer Posted / pratik
Sir,
I am preparing the JSPL exam this year on electrical
section, can you pleas send the question paper pattern to
me...
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
How we can determine short circuiting current any plant and for example a plant which power generation is 415 volts and plant load is 500 kw.
who many types of fire explane with exmple
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
How to address the servo drive for motor
static chagre
