Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / anupam
power factor is ratio of;
cos(phi)=resistance/impedance,
impedance > resistance, in a given ckt hence,
power factor<=1
| Is This Answer Correct ? | 2 Yes | 6 No |
Post New Answer View All Answers
In which of the following case, the rotating magnetic field is reversed? A regenerative breaking B plugging C dynamic breaking D forward motoring
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
Why using synchronising methed in DG's sets?
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
why don't we use the generator as a motor? and what will happen?
how to changeover ups in this power failur time?
What is the different types of cable & current capacity of cable
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
how can we design robots
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
Why is back emf used for a DC motor? Highlight its significance.
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
Please explain, how to test vector group of tranformer(Delta y1) . Thank
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
