Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gunasekaran
reactor is a coil it is using at electrical network it
supply inductive reactance to the system.
there are two type of reatance
1.shunt reactor.
2.series reactor.
shunt reactor is used at EHV line for reducing the ferranti
effect.
series reactor is limit the fault current it is connected
B/W two system.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is step signal?
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
Draw a block diagramof Three UPS systems connected in Parallel mode?
for 750 kw LT load what will be the ht kva
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
should %impedance be high or low in a power transformer? if so why?
what are safety measures in /control in diesal engine/ explain them?
What is the disadvantage in proportional controller?
How to megger test 11 kV cable and the acceptance IR value
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
what is the difference between gas group b and gas group c electrical equipment construction wise?
If one tertiary phase i.e. R,Y or B is earthed of a loaded type tertiary delta connected (Without load)of a power auto transformer, what is its advantage/disadvantage?
what will be d.g. capacity to cater together for 14hp A.C. load & 3kw lighting load
Formulae for calculating the transmission line losses for different voltage levels
