what is gear ratio & how it can calculate
- 9 Answers
- 32833 Views
- MAHINDRA, I also Faced
- E-Mail Answers
Answer Posted / pjagan89
Gear ratio is defined as the ratio of number of teeth on the
gear to the number of teeth on the pinion.
G= T/t
T- Number of teeth on the gear.
t= number of teeth on the pinion.
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
What is a pneumatic system?
what is the difference between under vacuum & under pressure boiling?
SOMEONE POST THE MODEL APTITUDE QUESTIONS FOR MRF TYRES PLz pLZ pLZ ..Very urgent
Give an introduction to bourden pressure gauge?
Explain important rules that must be kept in mind while designing castings?
what is your specifical way of dealing with conflict.
Why can't we use antifrictional bearing in place of journal bearing in a 660mw plant
Explain how the cylinder lubrication on main engine is done?
What is meant by effectiveness?
how we calculate the induced air capacity of id fan of a boiler?
I've been running into situations where a relief valve is being used to protect a regulator. Is this common? And, is this a proper use of a relief valve?
Which pipe should I use SAW, ERW or seamless if I have the following constraints I have to transport methane gas Size is 8” Corrosive environment Sulphide is present Also tell the cost comparison
What causes friction in the cylinder?
Explain the fresh water cooling system.
"In refrigeration, why during operations is running low pressure at the suction side?"
