How earth resistance reduses by pouring water coal and salt?
Answer Posted / gkumar
Hi,
Both coal & salt acts as good conductor of electricity .
also when they are mixed & put in the earthing pit they
provide conductivity as well as moisture for better passage
of current
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
How you will determine the volume of oil in a particular Distribution transformer.
What happen in ups if phase reverse?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
xpression 'document.FrmQF.myemail' [
define digital electronic
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
How to Make relay co ordination chart for a Electrical power distribution of a plant
Hoe do calculate the Cable size for Amps rating ?
What is the importance of earthing?
Can i replace Earth leakage relay to the faulty Earth Faulty Relay
What will happen if we introduce negative feedback to a control system that uses a positive feedback?
If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
what is upper impedance and lower impedance of a distance relay
What is superposition theorem?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.