Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sushant
Power factor is the ratio of Active power to its Apperent
power
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
why we can stote dc? why we cant store ac?
What is electrical grounding?
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
What are the Full Forms of TVM, MTL, CVT ?
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
how is capacitor bank look like
can you please send me the technical questions and aptitude questions of honeywell and jindal steel electrical engg. question paper my e-mail ID is(kkesavanraj@gmail.com)
How to run a three phase motor into single phase........
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
how oil in the MOCB was reduced compared with OCB? what are the features of the MOCB?
can i connect the two phases of scott connected transformer,if not why?
