Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ansab
The definition of droop is the amount of speed (or
frequency) change that is necessary to cause the main prime
mover control mechanism to move from fully closed to fully
open. In general, the percent movement of the main prime
mover control mechanism can be calculated as the speed
change (in percent) divided by the per unit droop.
| Is This Answer Correct ? | 55 Yes | 8 No |
Post New Answer View All Answers
How will you define capacitance?
In dc ckt. 24v or 110v, which one is more efficient and why?
Can we Co-ordinate relay in Load Break switch?
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
what reactive how to maintain
What are the differences between single phase and three phase?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
how invertor convert the dc into ac give brif detail
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
What is the use of iron core in a transformer?
In siemens PLC, why do we want to move the data ?
What happens if we run alternator on under frequency?
how many types of motor can be used in washing machine
could you measure current in parallel?
