the voltage per turn of a primary winding of a transformer
is the same as the voltage per turn of the secondary
winding of the transformer. why?
- 8 Answers
- 24286 Views
- I also Faced
- E-Mail Answers
Answer Posted / saranya
E2/E1=N2/N1(Voltage transformation ratio)
E2/N2=E2/N1.so the emf per turn is same.
| Is This Answer Correct ? | 10 Yes | 5 No |
Post New Answer View All Answers
george phenomenon of synchronous machine
how 650 volts creates? where is use?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
If any one's require of phoenix contact like( relay , termilnal block , surge protection device ) , product please contect me 09878206357 chetan verma
What is the diff. between single compression and double compression gland
by what factor the starting current is used when comparing star and delta connection for motor starting?
why most of junction box vendors providing T5/T6 Temp class jb's for T3 area any special reason?
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
What is inrush current?
How to calculate capacitor bank value to maintain unity power factor with some suitable example?
why the colour of insultor stack , petticoat is brown. Is it has some technical reason.
explanation of mesh bus bars
why ahould you show client/engineer activities clearly on the project plan
