Interested to Buy Any Domain ? << Click Here >> for more details...
What is R/X ratio?
I have heard that this ratio is higher in a radial
distribution system.Why is it so?
I would appreciate a word.
Thank you
- 1 Answers
- 21085 Views
- Power Grid, Vignan University, I also Faced
- E-Mail Answers
Answer Posted / jagadeesh
X/R ration means (line reactance/line resistance)
for short transmission lines it is X/R<3.0
long lines it is >3.0
because long lines length of transmission line is due to
this inductance is more(L directly proportional to length of
line)
for short lines L is low due to this X is low (X=2∏FL)
some value divides low vale it is always high(ex: 1/0.1=10)
| Is This Answer Correct ? | 15 Yes | 24 No |
Post New Answer View All Answers
what is current check gurd relay?
what is settable hystersis protection? If any body knows plz kindly post the answer..
If o/p power is doubled by how much does the sound increase
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
why we use 630mm single core cable for transformer secondary side and why two neutral cable
What is Harmonics how it is produced and what is the method to control the same
What is the effect of pd controller on system performance?
The capacitive reactance of a capacitor of 1/(2(PI)) F at 10^3 H is
What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.
What OPGW is better than Microwave or PLCC???
how we calculate the dick for a pole?
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
What is Fire Panel ? How it works ?
what is the minimum winding resistance of 30hp compressor, to run or to switch on
SUTIABLE FOR ohm's law super conductor
