Interested to Buy Any Domain ? << Click Here >> for more details...
I have a transformer whose primary operates at 230V, 50Hz
for which the secondary voltage will be 12V, 50Hz. What
will be the secondary voltage if the primary is fed with
400V, 8KHZ Signal?
- 6 Answers
- 9805 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / raj(b.e.electrical)
e1/e2=e3/e4
230/12=400/e4
e4=400/19.16667
e4=20.869v
so ans is : 20.869v
freq remain same.
| Is This Answer Correct ? | 4 Yes | 5 No |
Post New Answer View All Answers
im electrical engineer, could any one help me for FEWA exam questions please ?
What should be the height of basement according to NBCC code?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
In 90 kva alternator that produce the output voltage is 115(p-n),200(p-p) at 1500 rpms means what ampere it produced ?
what is a reactive power? what is the relation with power factor?
WITCH CARDS IN USE IN FIRE CONTROL PANEL.
Explain in details how you would react to an unexpected incident when your supervisor or manager is not around to give instructions?
how the works electronic energy meter?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
Power Factor Correction Panel (Manual & Automatic)
what is the function of gss in the dg set.
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
What is the ratio of true power to apparent power in an ac circuit?
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
what types of electrical & mechanical test conducted in switchyard?
