Answer Posted / rated kuldeep
AC transmission is used as compared to DC because for
following reason... AC can be transformed to low current
high voltage configuration using transformer. Conductor size
required will be less and hence more economical...... 2nd
reason which is main reason is AC is bidirectional hence has
ability to move in both the directions ...
DC can be transformed according to need but costly
rectifiers are neede heence for buulk power transmission ac
is used... correct me if wrong.....
| Is This Answer Correct ? | 23 Yes | 3 No |
Post New Answer View All Answers
Define availability (operational)?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
difference between Ac and Dc mcb ????
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
why should the primary of transformer be connected in delta in a heat run test?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
why only exciting current is shown not primary current in transformer???
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
What are the types of transformers according to the arrangement of iron cores?
what is x'mer ,isolation x'mer & yltra-isolation x'mer?????
Why computer humming sound occurred in ht transmission line?
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
