Why effective AC resistance is more than DC resistance of a
transmission line?
- 9 Answers
- 23087 Views
- HCL, ONGC, I also Faced
- E-Mail Answers
Answer Posted / paridhi jain
because it is concentrated at d surface while dc resistance
is distributed uniformly throughout d conductor
| Is This Answer Correct ? | 19 Yes | 2 No |
Post New Answer View All Answers
what is the minimum voltage require to injure our body?
how to get electrical supervisour certificate in gujarat
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
Explain in details how you would react to an unexpected incident when your supervisor or manager is not around to give instructions?
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
What is the difference between resistance grounding system and resistance earthing system?
DG SET BLOCK DIGRAM
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
How will be the single line diagram of series trip HT breaker? how it works?
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
What is depreciation factor?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
When MICC cables used ?
