Interested to Buy Any Domain ? << Click Here >> for more details...
Why A.C. capacity given in Ton.
Ex. - 1.5 Ton
- 4 Answers
- 25216 Views
- Samsung, UltraTech, I also Faced
- E-Mail Answers
Answer Posted / rajeeva kunwar
The air conditioner capacity is measured in terms of Ton or
BTU (British Thermal Unit). BTU refers to the amount of
heat energy required to raise the temerature of 0.45 kg
water by 1 degree Fahrenheit. 1 ton AC is equivalent to
about 12,000 BTUs.
| Is This Answer Correct ? | 27 Yes | 7 No |
Post New Answer View All Answers
Define what is difference between fuse and breaker?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
what is x'mer ,isolation x'mer & yltra-isolation x'mer?????
BSNL TTA EXAM QUESTION
in my industry we are using 3 step up transformers for induction heaters..i.e 415/580v and other are 11/440v.in power consumption does a step trnsformer makes any difference compared to step up?? plz explain
what is resver in electrical enginnering with answer
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
how to design the heater in temperature control unit to heat 50KL of water?
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me
how test transfomer(3 phase75kva) by megger
