Interested to Buy Any Domain ? << Click Here >> for more details...
In Battery Charger - What is the meaning of End Cell
Voltage and Float Voltage.
- 9 Answers
- 42901 Views
- FLSmidth, Focus, PSEB, I also Faced
- E-Mail Answers
Answer Posted / subramanyam
Folat voltage is that; the out put voltage of the charger
just above the battery set voltage which is sufficient
enough to charge the set of batteries, without allowing the
battery set voltage to drain its attained value.
| Is This Answer Correct ? | 18 Yes | 5 No |
Post New Answer View All Answers
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
Why we cant store an ac power. If we coo store in which device we can?
For electrical designers what are the standard should know? i want learn about this standards. how to get information/reference. anybody help in this regards please.
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
How many types of electrical earthing are there?
what are the stresses in circuit breakers ?
please tell me how a surge protector work on a DC 48Volt.? please describe briefly.
Define delay time.
How to reduce -234126219.6403 MVAr generation and by what?
How to calculate mf when meter equipment and meter are connected
State Maximum Power Transfer theorem.
Initially, when the input is not equal to the output — what type of response is this?
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
