how can calculate the hight of chimny in a power plants
- 4 Answers
- 5390 Views
- I also Faced
- E-Mail Answers
Answer Posted / sharath
It is depends on the pressure of flew gases
| Is This Answer Correct ? | 8 Yes | 4 No |
Post New Answer View All Answers
How do you define mechanical efficiency in case of compressor? How it is different that of an IC engine?
How can I weld A234 WPB and WPB P11 fitting? Any special heat treatment required? What happen if I weld both?
what is the velocity considering in lube oil drain line for lube of system for steam turbine?
Why and what cause of leak fuel oil in high pressure pipe of main engine?
Is it ABS AH 36 material equivalent to IS 2062 Gr B material.
What is a uniformly distributed load?
Why coupling should be located very near to the bearing? Why lap joint not recommended for tensile force?
why do u ant to join the indian army??
What is the indication of leaking starting valve of an engine?
If anybody have the ref. design book of the 3 point cylindrical rolling with sheet thickness of 2.3 mm & 67 mm internal diameter legth of 80 mm
Why RPM cum hour meter connection is not possible in water cooled DEA set. Is there any problem in sensing?
I NEED PREVIOUS YEAR QUESTION AND ANSWER FOR RRB JR.TECH- ENGINEER-3 FOR DIPLOMA VERSION.PLEASE SEND ME URGENT.MY MAIL ADDRESS IS vadivelu2000@gmail.com
A very strange fault i cam across today,that i never experienced not studied before, i need an answer for this. Phase to phase or line to line , L1,L2 & L3, voltages are 490VAC, but if i use line to ground , its again 490 VAC. . . whats the fault and theory behind of it?
pls send the technical question paper
How are pipe flanges electrically insulated?
