Interested to Buy Any Domain ? << Click Here >> for more details...
Why we use 250 ohm resistor in series with HART protocol
communication?
- 13 Answers
- 58375 Views
- Chemtrols, Instec, Sabic, I also Faced
- E-Mail Answers
Answer Posted / ankush
for load resistance and to follow the international standard
for dcs i.e.1 to 5 volt.
| Is This Answer Correct ? | 20 Yes | 12 No |
Post New Answer View All Answers
full process of gas turbin?
please send the sample qustion paper for iocl written test ..
what are the use of belew gear in general ??
What is the difference between ff transmitter and non ff transmitter
1.what is the effect of vapour presuure in orifice plate flow measurement 2.which is more effective 2 pressure sensors or one single differential pressure sensor in orifice plate measurement 3.how to design a v/i converter and i/v converter 4.how many type of thermocouple are there 5.how many leads are there in thermocouple measurement 6.how pressure sensors are connected in level measurement in differential pressure method 7.what is the output of capacitive pressure sensor (ac or dc),how its o/p is signal charactarized 8.what is the physical meaning of discharge coeeficient,why it is calculated,orifice plate what is its value,why it is less than 1,Q at upstream is equal to or not equal to Q at downstream of orifice plate why?what is vena contracta in orifice plate 9.why rotameter is called variable area flowmeter,it can measure flow even if area is not varying,why it is made tapered 10.design a 10 bit counter ,which counter you will prefer 11.how to remove self heating error in RTD 12.which is more sensitive pt100 or pt50 13.why thermocouple are connected in parallel 14.what is lead contact error in RTD,how to avoid 15.what is P,PI,PID,PD controller,why there is no ID controller 16.what is override,split range,sequential,ratio,feedforward,cascade controller 17.why we moved from SR to JK and then JK to master slave JK flipflop,give correct reason 18.how to measure level of a closed container which contains vapour and liquid,remember no vapour gas should be leaked,so ultrasonic and capacitive is not an option,design another method 19.how to design horse race counter including sensors and signal conditioning element 20.what is bevelling
We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.
Explain the use of hair spring in the pressure gauge.
what is the diffrence between pressure safety valve & pressure relief valve....pls
what is the difference between scaler and vector drive
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
how do we commission inergen system?
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
What is hp & mp seperator .& what is its working principle ?
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
