Hi, I have packet tracer 5.0. I want to test intervlan
routing routing. Can someone plz tell me about intervlan
routing?
Answer Posted / jitendera sinha
ok here i am trying for intervlan routing
what is vlan
vlan is virtual lan which is used for break the single broadcast domain of the switch.some we also say that it is used for security across the lan.
ok how we create it
switch#vlan database
swirch(vlan)#vlan 2 name sales
#vlan 3 name hr
ok by this way you can assiagin vlan to the switch
now assighn interface to the particula vlan
sitch#config t
switch(config)# interface fa0/1
#switchport access vlan 2
#switchport mode access
#exit
#interface fa0/2
#switchport access vlan 3
#switchport mode access
#exit
similay u can assign range of interface for particular vlan
comand is
switch(config)#interface range fa0/4 -48(for phycial router)
or
witch(config)#interface range fa0/4 -fa0/48 (for boson or any other)
sitch(config)#switchport access vlan xx
switchport mode acess
after doing this you have to assighn ip for the particular vlan
switch(configt)#interface vlan 2
#ip address <ip address> <netmask>
simlary for vlan 3
note< you should not configure vlan 1 becoz it is default one>
now you have also assign default gateway address to switch
switch(config)#default-gateway <ip address>
ok
now from here you are not able to ping vlan 2 from vlan 3 and vise versa
note since vlan is virtual lan they you should assign same class of ip address with same mask and with same default gate way
if you assign 10.10.10.0 /24
then you should assigns this ip for ip address not 10.11.10.0 or 11.11.11.0 only 10.10.10.0/24 remember
many of the student done mistake and nikhil is master in that(kiding soory)
ok
now your requirement is that ok a vlan should access some particular service from network but some are deny for that
so we introduced a router with fast Ethernet to that network
this process is called interfvaln routing
how it will be done i will say u in eving with example becoz i am in office till then paractc for vlan creation
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
Mention what does the clock rate do?
Which type of transmission bus topology support?
What is the difference between full duplex and half duplex?
How does Hold-downs work?
Which decision called socket base?
What are the conversion steps of data encapsulation?
What are the advantages of using switches?
Value in which type of access list?
What is the size of IP address?
Explain what is 5-4-3 rule?
What is an autonomous system?
What does protocol mean?
Define the virtual channel?
Can you explain in a generic manner the packet of IPSec?
I simulate ten routers r1 to r10 straightly. I want I can ping from the loop of r1 to loop of r10, but I want I cant ping r1 and r10 from inside routers.?