Answer Posted / sujeet kumar

1. In HV side current is less so there is less sparking
2. ON the transformer core first we placed LV winding and
above it we place HV winding. Hence it is practically very
difficult to tap from LV winding.

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

2023

---

State the other types of Air Conditioners?

2047

---

What are m circles?

1089

---

induction 3 phase motor terminal connection

2652

---

what is the correct format to create a resume for interview??

1966

---

I need HT sphere gap calibration table. Can any body help me.

1938

---

What is minimum phase system?

1129

---

What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.

1706

---

What is distance between electrical panel to land ?

1527

---

How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.

1490

---

Electrical 'C' license full abbreviation , and full form

1877

---

plz tell me,ht and lt panel terminals in substations explain beiefly

2918

---

what is the write prosidure of stringing of 8meter pcc pole.

2439

---

when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil

1703

---

If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?

1141

---