Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / elecrk
an oscollator is which genarate to any frequency
oscillations without using any input signal
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why does the rotor rotate?
what is the max. acceptable leakage current in 33kv bus bar
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
On what principle electric motor works?
what is the transformer turn ratio formula and give some examples?
What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?
if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?
How to do stting of vl250 siemens MCCB
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
explain PV modules in solar energy generation.
How can we findout the maximum efficiancy of Transformer? At which load?
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
what is ratio of copper wire size and current ?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
