Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mukesh tyagi
U0-Initial Voltage
U-Final Voltage
| Is This Answer Correct ? | 0 Yes | 34 No |
Post New Answer View All Answers
What are the classifications of heating element?
why we not used 11kva as a direct our electrnics component.
What is Traction? 1KVA Alternator, How much urrent taken?
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
why the active power flow of some line is increased when the active power of out is cut ?
What does the a,b,c of 95a,95b,95c relays denotes?
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
Post possible questions for Power Factor Panel FAT / SAT
How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?
what is the id1 & id2 setting in differential protection relay of CSPC?
how to get bearing & winding temperature of an induction motor?
What is reverse power relay?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
how to calculate voltage drop and followed by cable calculation?is there avail in formula?
