Interested to Buy Any Domain ? << Click Here >> for more details...
How do we MEASURE OR CALCULATE VELOCITY used to calculate
REYNOLDS NUMBER??
- 3 Answers
- 8658 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjay
REYNOLD NUMBER : It means rate of flow.
Re = p VD/u
Where
Re = Reynolds Number, v = Velocity of flow in m/s, d =
diameter of pipe in m, p = density of fluid in Kg / M³,, u
= Viscosity of fluid.
Turbulent or laminar flow is determined by the
dimensionless Reynolds Number.
The Reynolds number is important in analyzing any type of
flow when there is substantial velocity gradient (i.e.,
shear.) It indicates the relative significance of the
viscous effect compared to the inertia effect. The Reynolds
number is proportional to inertial force divided by viscous
force.
• laminar when Re < 2300
• transient when 2300 < Re < 4000
• turbulent when 4000 < Re
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
if my flow is 20000 m3/h than which range of DPT i have to use????
all types instrumentation questions want
What is the reason PT speed not incresed in gas turbine?
what are the use of belew gear in general ??
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
What are the types of control valves available
What is instrumentation technologists and mechanics?
What is three element drum level control system why its better than single element?
how to relay switch sense the fault?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
what is the protection system in solar turbine compressor
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
