Interested to Buy Any Domain ? << Click Here >> for more details...
what is dead weight tester and where it is used?.
- 11 Answers
- 21847 Views
- DuPont, Jain steels, I also Faced
- E-Mail Answers
Answer Posted / vinod
Deadweight Tester (Pressure Balances)
are the most accurate instruments for the
calibration of electronic or mechanical
pressure measuring instruments. The direct
measurement of pressure, according to its
definition as a quotient of force and area,
and the use of high-quality materials result
in small uncertainties of measurement and
an excellent long-term stability of five years.
For these reasons, deadweight testers
have already been used in calibration
laboratories of industry, national institutes
and research labs for many years.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
What is rang ability?
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
How can a d.p. Transmitter be calibrated?
Explain how thw analog to digital converter works with the circuit diagram
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
What is the use of gauge?
full process of gas turbin?
what is the difference between attemperator and desuperheater ?
Explain the working principle of lvdt?
Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
