Interested to Buy Any Domain ? << Click Here >> for more details...
hi... i am usin packet tracer 5.0.. i hav connect two
routers A and B. A has 200.100.25.100 and 1.0.0.1 and router
B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1
and 1.0.0.2... now i want to route 200.100.25.100 and
200.10.50.100 usin rip.. i enable rip in both the routers...
but whn i give the command show ip route... i jus get this
Codes: C - connected, S - static, I - IGRP, R - RIP, M -
mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA
- OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF
NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF
external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 -
IS-IS level-2, ia - IS-IS inter area * - candidate default,
U - per-user static route, o - ODR P - periodic downloaded
static route Gateway of last resort is not set A# so can
sombody tell me where i hav gone wrong...
thanku
- 4 Answers
- 13632 Views
- I also Faced
- E-Mail Answers
Answer Posted / karan
hiii buddy
when u enale rip in ur router
after that u hav to giv network address
like this
router(config)#router rip
router(config-router)#network 200.100.25.0
router(config-router)#network 1.0.0.0
router(config-router)#exit
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
What is half duplex and full duplex?
How are internetworks created?
What is fcs?
Which protocol can do load balancing on unequal cost also?
What is the icmp protocol?
How many ways to access router?
What are partial updates?
Differentiate User Mode from Privileged Mode?
What are the netbios and netbeui?
What are the differnt memory use in cisco router?
What is the working of router?
Why is vlan used?
When we use extended access-list?
Name the vtp modes?
Explain the difference between rip and ripv2?
