What is the min.& max distance between two earth spikes is
required for measuring earth resistance of an earth pit? Is
the manufacturer of Earth tester decides this? Pls explain.
Answer Posted / prem devkota
the minimum and maximum distances are 5 and 10 meter in
practice. But in general manufacturer declares the distance
requirement.
Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
why single CT used in DOL starter power circuit?
Define non-touching loop.
how to get electrical supervisour certificate in gujarat
Give the topology of current amplifier with current shunt feedback?
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
what is deffrence between squirral cage and wound rotor in IM?
What are the two basic types of transformers?
Explain advantages of storage batteries
what is the difference between electrical and electronic choke?