Answer Posted / gopiim
bhkdvjshjksdfhjfkl;hg
Is This Answer Correct ? | 6 Yes | 16 No |
Post New Answer View All Answers
How many double suspension hardware fittings are required on a double circuit transmission tower?
Give accurate definitions for these electric terms: Inductor Inductance Inductive Induction Reactance Reactive Esam Baraka ٢١ ساعة
what ispositive, negative, zero sequence impedence?
what will be d.g. capacity to cater together for 14hp A.C. load & 3kw lighting load
how you configure motorvision relay (L&T make)from DCS
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
the problem faced on star or delta winding connection??
EXPLAIN METOD OF IMAGE OF TRANSMISSION LINE/ WHAT ARE ITS PRACTICAL APPLICATION?
hello if any one have papers vof hpcl or sail, plz send me
how technical is calculated in 11kv line and lt line
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
How to set a Zone 1 distance relay for distribution feeder?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?