Interested to Buy Any Domain ? << Click Here >> for more details...
why transformer ratings in kva?
- 99 Answers
- 234887 Views
- Bhel, College School Exams Tests, DOW, Emco, Esab, GE, KCP, PGCVL, Sodexo, TCS, vtps, Wipro, I also Faced
- E-Mail Answers
Answer Posted / m. jamshed
As transformers are the power source and every power source
is deigned for specifid value of current and voltage.
The amount of current in A/C circuits is greatly affected
by p.f.as if we take two examples for the same kw with
different p.f we will get different amount of current that
is high current for low p.f and vice versa.
For the transformers we do not know about the load p.f,so
it will be rated in kva to determined the exact value of
current it can provide.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Differentiate between low pass, high pass and band pass filter?
how to convert lv line to hv line and viseversa, any losses will occur during this process
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
Formulae for calculating the transmission line losses for different voltage levels
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
what is the meaning of vcc
What is the high series capacitance winding on high voltage power transformer ?
Define characteristics impedance?
What is the formula to calculate a three phase alternator
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
what is the difference between neutral and earth
How do u analyse protection fault when vcb tripping on load
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
