what are diffrent types of pneumatic conveying systems?
- 3 Answers
- 4435 Views
- I also Faced
- E-Mail Answers
Answer Posted / rohit ginoria
Dense Phase pnuematic conveying system (air:material is
below 25:1) and Lean Phase(air:material ratio is aboe
100).. There is also another category lying in btwn. Just
not remembering the exact name. The ari to material ratio
lies within 100 to 25.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to calculate bearing width
Which reactor uses heavy water as moderator ?
have a clutchless car or bike clutch for power transmission???
What is the purpose of bilge separator
how current flow found at one and of generator ,at star neutral point each phase.
what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.
In a rankine cycle if maximum steam pressure is increased keeping steam temperature and condenser pressure same, what will happen to dryness fraction of steam after expansion ?
What is the most economical spacing of buttress ?
How Much static pressure as per NFPA standard is required in the hydrant line?
Contaminants of fuel oil
What will be the cause of high temperature in one cylinder of D/E?
As compression ratio increases, thermal n increases. How is thermal n affected by weak and rich mixture strength ?
Who invented springs?
Explain the types of elasticity?
Why air is not used to run the turbine?
