Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / asm
to remove (not eliminate) offset
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Isometric drawings are generated during _________________ phase of a project
Draw symbols of the following :
What is 1:1 redundancy ?
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
Why trim span ? How?
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
How does temperature bath work? How does coil gets heated only by applying some current?
draw shematic diagram of c/v positioner(smart type)?
What is the use of temprature compensation?
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
