Interested to Buy Any Domain ? << Click Here >> for more details...
what will hapen if secodery circuit is open of current
transformer
- 8 Answers
- 18800 Views
- KPTCL, I also Faced
- E-Mail Answers
Answer Posted / santhosh
its depend on the windings if secondary more no winding
compare to primary then it do not effect it
| Is This Answer Correct ? | 2 Yes | 10 No |
Post New Answer View All Answers
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
Explain about retrofitting of machine tool.
what is ground fault in ACB?
i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400
is the value of inductance depends upon the evalue of thitha in doubly excited machine?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
What are the necessary components of the feedback control system?
how to calculate
What is the difference between voltages or potential difference? And what are they?
what about the power of wattmeter at starting and loding?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
what is frequency response?
I am a possesor of c licence from 1993. I forgot to renew during the year 1998. During that time I was working at TNEB to till date. Is there any possibility to get renewed? or to apply for a new one?
