Interested to Buy Any Domain ? << Click Here >> for more details...
IN A THERMAL POWER PLANT, WHY IS THE USED STEAM CONDENSED
INTO WATER AND THEN SENT BACK TO THE BOILER, WHY NOT
DIRECTLY REHEAT THE SAME STEAM??
- 12 Answers
- 33653 Views
- I also Faced
- E-Mail Answers
Answer Posted / kumar
after last stage, the pressure & temperature of the steam
is very less. so that it can't travel further any area.
so that we have to condensate that steam and pump it to
boiler reheater. With less pressure steam can't travel
upto boiler height. That is why we r changing the phase
from steam to liquid. We can pump the liquids very easily
than steam. Another point is in condenser, there are lot
of non-condensable gases will present in the media. Those
gases we have to remove. If u reheat the same steam, due
to these non-condensable gases, the boiler tubes may
damage. So we required to pass this liquid to deaerator
also.
| Is This Answer Correct ? | 24 Yes | 3 No |
Post New Answer View All Answers
While finding the velocity of gear B , in case of a simple epicyclic gear train, why do we take tke velocity of gear A to be ZERO(0)if the arm is rotated with speed equal to that of gear A and in opposite direction?
Name two vital conditions of a perfect gas.
Name Of Parts And Each Purpose
"What is fuel oil viscosity, specific gravity?"
What is a vee used for on the vee block?
What is churning effect of turbine
Give five differences between suction and discharge pipes?
difference between aerofoil meter and orifice meter
how can i access syllabus of different psu.plZ help me
Define radiation.
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
The lowest allowable insulation resistance?
what is cyclon seperator and water column?
what is STOCT TURN OVER RATIO
Why pistons are usually dished at top ?
