what are the mixing of M10,M15,M20,M25,M30grades?
- 4 Answers
- 15032 Views
- GMR, I also Faced
- E-Mail Answers
Answer Posted / akshay barman
the mixes of grades M10, M15, M20 and M25 correspond approximately to the mix proportions (1:3:6), (1:2:4), (1:1.5:3) and (1:1:2) respectively.
| Is This Answer Correct ? | 46 Yes | 4 No |
Post New Answer View All Answers
What are the RISKS during the project construction?
How foundation is designed, Column design and beam design
though u r a civil engineer, y r u interested in tcs???
what is the water cement ratio for plastering
What is the basic difference between OPC
estimate quanitity of bricks(19x9x9cm without mortar), cement & sand in 10feet X 10feet wall ?
Can we use Polystyrene as a Bitumen modifier !! if so is it a good MS research topic ? and what type of laboratory tests will be conducted during Research work ??
What in your opinion makes you the most suitably qualified candidate for this post of civil engineering technician?
what are RIB slabs explain about it
If specific gravity of cement is less than 3.15 what is the cause?
Which code specifies the specification ofthe construction joints to be provided in the raft slab of a basement which is 6 m deep.what should bethe detail of such a joint?
In tower foundation, on the time of 3 mtr pit RCC casting if water and mud is their surface of PCC then what will be do?
percentage of metal,clay or soil & water in water bond macadam roads to know the quantities for each in total volume of 11500 cubic meters
What is the difference between engineering stress and true stress?
what will happen if one could not properly follow the spacing of slab reinforcement bar?
