what are the different types of terminal lugs used for
wiring termination?
- 5 Answers
- 22882 Views
- Yokogawa, I also Faced
- E-Mail Answers
Answer Posted / vinesh prajapati
Generly two type of lugs
A) soldering type.
2) clamping type.
Other types depend on shap as mention
'U'type lug.
'O' type lug.
'pin'type lug.
'flat'type lug.
'bullet'type lug.
'c'type lug.
| Is This Answer Correct ? | 29 Yes | 2 No |
Post New Answer View All Answers
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
I have completed B.E. Instrumentation & control in 2009. i have 3 year industrial job experience in chemical plant.now, I want to join M.E. in external. so, Plese say easiet way and good institute name.
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
What is the difference between mmwc and mmwg?
Draw symbols of the following :
What is rang ability?
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
how many types of spped sensors n vibration sensors?their basic principle n connection?
Why do you want to work here
How would you choose differential range?
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
What is the use of each wire in three wire RTD
What is the minimum rating availalbe for weld neck orifice in market?
