what is dead weight tester and where it is used?.
- 11 Answers
- 18326 Views
- DuPont, Jain steels, I also Faced
- E-Mail Answers
Answer Posted / vinesh prajapati ,guj. +919974
Dead Weight Tester is Master calibration equipment for
calibration of Low & High pressure ranges, Instruments i.e
Transmitters,Switches, Gauges.
Pressure=Dead Weight/Area of piston
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Why mmwc unit is used?
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
Explain why use mmwc unit?
How will you calibrate PID controller? explain with example.
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
Can anyone convert a 5/2 way or 3/2 way valve into an ISO valve?
Draw a great bridge circuit.
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
what is function of SCADA , and how is it work, explain with difination
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
what is output of FOUNDATION FIELD BUS transmitter
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
In turbine what does term CDP, NI, NH, HSSOC means.
What is 3 selection available when configure the burnout protection for controller
What is zero elevation and zero suppression?
