A 11000/415V distribution transformer is fed 415V upon it's LT
side,Do I get 11000V upon it's Primary side ?
Answer Posted / varun
depends on whether the tiptronic bipolar cypersistors are
actived or are in semi transgulocitural state
Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
HOW CAN WE DECIDE THE SUPPLY VOLTAGE FOR MOTOR ACCORDING TO ITS RATING(IF ANYONE KNOWS GIVE IT WITH EXAMPLE AND ITS CALCULATIONS)
hi friends how 3 phase converter functioning ?what is working principle of rotory phase converter ?
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
What is the safety of UPS?
What does quality factor depend on in resonance?
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
explain the types of drives
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
why moisture formation found in XLPE Armoured cable outer sheath
If 24 KVA AVR having Input voltage 200-400v, Output voltage 415+-1%, what will be the voltage if Load is 13A.
what is the difference b/w ATS and HTS?