Interested to Buy Any Domain ? << Click Here >> for more details...
what does the regenerative braking mean?and how it used for
Dc motor? thanks.
- 2 Answers
- 6883 Views
- I also Faced
- E-Mail Answers
Answer Posted / t.somasundaram
regenerative braking is a method which is used to to stop
the DC motor immediately against moment of inertia.A
regenerative brake is a mechanism that reduces vehicle speed
by converting some of its kinetic energy into a storeable
form of energy instead of dissipating it as heat as with a
conventional brake. The captured energy is stored for future
use or fed back into a power system for use by other
electrical equipment.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
which type of questions asking for solar companies?
Why single phase induction motors are not self starting ?
What is the automatic voltage regulator with servomotor?
what ispositive, negative, zero sequence impedence?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
what is Fault level? why it is calculated? how will u decide same for our plant?
why u r living from presentaly working.
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
BSNL TTA EXAM QUESTION
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
What are the special cables required for explosion proof wiring?
What does the a,b,c of 95a,95b,95c relays denotes?
