Interested to Buy Any Domain ? << Click Here >> for more details...
why the tapping of transformer on ht side??????
- 12 Answers
- 41785 Views
- CTS, OPTCL, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / binay agrawal
in hv side, current will be less; so if we vary the
rheostate, than thetre is less arcing with respect to lv
side, so we always put the tap changer in hv side.
| Is This Answer Correct ? | 41 Yes | 2 No |
Post New Answer View All Answers
What is the formula of frequency ?
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
what is mean by Digital Logic Meter (DLM)
What is the IS standard for MCCB to be use (As per capacity of AMP)& for ACB also.
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
what the principle of sincroscope?how it works?when it needed?
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
If any one's require of phoenix contact like( relay , termilnal block , surge protection device ) , product please contect me 09878206357 chetan verma
What is phase cross over frequency?
What happened when capacitor connect series in ac circuit?
what is the difference between an alternator and a synchronous motor
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
What is the automatic voltage regulator with servomotor?
what is sevice settings for mccb?How can be it setted?
