what is the relationship between induction motor and
transformers?
- 11 Answers
- 31774 Views
- College School Exams Tests, Engineering, Reliance, I also Faced
- E-Mail Answers
Answer Posted / d.rajagopal
Both are working Electro magnetic Induction princeple, but
Transformer is a more efficiency comper then Motor
becs Transformer is no moving and Rototing parts there is
no lose so high efficiency, Motor have meny lose so itis
low efficiency comper then Transformer
| Is This Answer Correct ? | 44 Yes | 8 No |
Post New Answer View All Answers
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
can u please mail me the syllabus for GET exam for damodar valley corporation?
What is load boxes ?
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
how much UPS neutral erath leakage current.
What is the use of Surge Capacitor in LAVT?
What is the function of RCBO? What are the different sensitivity ratings & each application?
Generator,motor and alternator Working principal Please explain easily
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
Why the symbol of register is "zig zag"
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
how many parameters can integrate with fire alarm basically ?
thyristor controlled APFC panel design parameter?
