Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jyotirmaya
Creepage distance is the shortest path between two
conducting parts of a circuit measured along the surface of
the insulator.
| Is This Answer Correct ? | 27 Yes | 1 No |
Post New Answer View All Answers
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
what is Anti-pumping?
How to calculate multiplication factor in kva example 500kva ans pls ?
What happens when two positively charged material is placed together?
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
how to set the time in digital timer ?
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
what is (+) and (-) in generator field detector stand for?
what is package substation.how many types they have
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
What is order of the system?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
How to find out damper winding failure for synchronous machine?
