Brief working principle of fluorcent tubelight,function of
starter & choke.
- 3 Answers
- 22658 Views
- Havells, I also Faced
- E-Mail Answers
Answer Posted / baskaran.r
the answer given in 1 is ok. the starter is used to light
the filament to heat up The starter will conduct only with
220v once the lamp comes up the choke drops the voltage to
aprox.to120v and this voltage is will not make starter to
conduct
| Is This Answer Correct ? | 15 Yes | 19 No |
Post New Answer View All Answers
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
Hello to all, Please someone can send me HPCL ELECTRICAL Engg. Sample papers to me? Its urjent....my email address is.... raviasiapacific@gmail.com
what is mean by parallel operation of permanent magnet generators
Why the arms of delta in a delta-wye power transmission system are kept constant??
When steam condenses and becomes water at the same temperature, the specific heat for the process in kJ/kg k is
how wecalculate breaking capcity of acb mcb mccb .explain with example
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
what is auto re-closer?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
how to calculate the distance relay faulty zone?pls explain?
what is zinc diffusion?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
How is the gain affected by the introduction of feedback in a control system.
