Answer Posted / balu

u have to maintain PF 0.99:-
u can use capactior:-
Log on to
http://www.nepsi.com/kvars_required_calculation.htm
select capacity of capacitor..

what is the use of the puls transformer in UPS & how it works???????????

2213

---

What is critical disruptive voltage?

1312

---

how to estimate wiring ins roughing ins. and boxes

2393

---

i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.

2112

---

Define filter?

1112

---

How we can determine short circuiting current any plant and for example a plant which power generation is 415 volts and plant load is 500 kw.

1984

---

In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..

1936

---

Iin ESP why positive is grounded ? why not negative ?

2641

---

what is the acceptable limit value for Desolve Gas Analysis/

1976

---

hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...

2671

---

If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?

4473

---

What is the maximum operating temperature for a thermoplastic insulated cable?

1126

---

I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?

1936

---

What is the rate of WCT on the Electrical Contracts comprising of DG Sets and Civil Works in Delhi ?

2181

---

How Calculet The UPS AH In Load

1890

---