Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / avinash .b. koli
the term earthing means connection of neutral to the earth
(ground).when any fault is occured then the fault curent is
given to earth to expose it . it is neccesary to protection
of operater.
earthing is done by a bare simple conductor
| Is This Answer Correct ? | 34 Yes | 12 No |
Post New Answer View All Answers
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
Define what is power quality meter ?
What is the test block protection relay if any body know plz explained
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
WRITEDOWN FEW RELY CODES
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
why we r not earthed Control cable of C.T. terminals
How can we findout the maximum efficiancy of Transformer? At which load?
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
what is the main function of capacitors in mccs.
Why we are going for converter transformers for DC drives application instead of distribution transformer?
why output is out of phase in case of common emitter?
How do we calculate over and under frequency tolerance from generator data?
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
