Answer Posted / abdul quadir khumani
Modulation = the technique by some parameter of carrier are
varied in accordance with carrier frequency is called Modulation
There are mainly three need of Modulation
1. Multiplexing = many signals can be transmitted at once.
2. Narrow Banding = low bandwidth required.
3. Height of Antenna = small variation in height of antenna
while change in frequency of signals is considerable..
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
The function of a transistor used in any of the ics is to perform switching action and not amplification. Then why diodes are not used instead of transistors as diodes also exhibit the same switching action?
minimum,maximum values of s12 in lossless & lossy txline?
Why is silicon preferred to germanium in the manufacturing of semiconductor devices?
What is meant by phase controlled rectifier?
Explain we take the area of collector wide comparison to base and emitter. Why?
What are the different methods to turn on the thyristor?
What is the right Step of Commissioning? (Commissioning, Hub Manager, Hardware)
What is ssb modulation?
can i give the short discription to "window size" , "Time out" "piggybacking" in sliding window flow control.
What is firing angle?
why the circuit turn off time should be greater than thyristor turn off time?
i want do telecom protocol development course from hyderbad convergence training school so what is the scope after doing that course and will i get a good job after doing the course and what will be the minimum package
plz send me any one gate papers
Explain the operation of 1φ sinusoidal ac voltage controller?
Hi dears, i work with E// switches since a bit time,i faces a problem with AFFILE output,when i get the out put (with Hex code) and i try to convert it to ASCII code it gives me the correct values but the data is not arrange correctly,there is some tabs,spaces and by result the data is shifted is there any advice for this case thanks & regards