WHAT IS THE MINIMUM IR VALUE FOR CABLE CHARGING
- 4 Answers
- 19099 Views
- Google, I also Faced
- E-Mail Answers
Answer Posted / pgr ram
for HT cables (6.6 KV to 33KV) above 500 megohms is
required. For LT cables (1100 volts) minimum 100 meg ohms
is required
| Is This Answer Correct ? | 20 Yes | 13 No |
Post New Answer View All Answers
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
Which is the oldest hydropower plant in india?
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
what is meant by motor startup supervision & motor load jam protection ?
What is purpose of reactor?.What is different between line and bus reactor?
What is an order of a system.
What does quality factor depend on in resonance?
why use phase displacement in transformer.and effect of phase displacement on transformer
What is the restart inhabit setting in ABB spam150c relay (Motor protection relay)
best manufacturer for busbar for outdoor switchyard having double bus bar scheme, can any one share technical specification of busbar. 132kv voltage ?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
How do apply electrical 'c'license......pls advice
how to failure indution motor insulation & how to improve heat in motor insulation
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
