Interested to Buy Any Domain ? << Click Here >> for more details...
What is Electrical Engineering?
- 13 Answers
- 19358 Views
- L&T, NTPC, Wockhardt, I also Faced
- E-Mail Answers
Answer Posted / sam
a study to increasing knowledge on power generation
utilization selection of devices along with the
characteristic analyze of protons and nutros
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
what is the use of piston rings in the engine used for a generator...........
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
How much load can take a 16 mm aluminum cable 3 phase
Tell me in detail about c.t. And p.t. ?
How many devices can be connected in one zone of FACP
diameter of cable and core is doubled then the value of capacitance is
Name the types of motors used in vacuum cleaners, phonographic appliances, vending machines,refrigerators, rolling mills, lathes, power factor improvement and cranes.
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
how to select rating of HT Panel
What is difference between isolator and circuit breaker?
What is resolution of a measurement?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
i need of the bhel question papers along with answers and also give some website names for the downloading question (electrical and electronics engg question)please help me....
When the relative speed between the magnetic fields of stator and rotor does is zero under steady state operation?
